What Georgia homes are up against.
NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31. · U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
A boiler sized a little too small for the house it serves can hide that fault through a short heating season, but Georgia does not offer a short one. Homes in Georgia run heat about five months a year, from November through March. A burner cycling across those months accumulates wear on the ignition system and heat exchanger at a rate that makes the initial sizing decision consequential in a way it simply would not be somewhere the equipment rests for most of the year. A contractor quoting a replacement in this state has to get the load calculation right before anything else, because the season will find the error if they do not.
A quote for boiler work starts with what the contractor finds inside the house, and in Georgia that picture varies more than the address alone suggests. Half the homes in Georgia were built in 1992 or earlier (2020-2024 ACS 5-year). A system that has been running without trouble can still carry undersized piping, an expansion tank that has never been checked, or heat distribution that was designed around a different fuel. None of those conditions announce themselves from the outside. A contractor has to open the system, read the pressure, check the relief valve, and measure the radiation before the specification means anything.
Does your county put extra wear on your HVAC system?
2015–2024 · Source: NOAA National Centers for Environmental Information, Storm Events Database.
A condenser sitting outside in Georgia faces hail, ice, wind-driven debris, and stretches of sustained heat that push equipment to work harder and longer than the rated conditions assumed. Where your county lands in this ranking tells you something real: how a contractor sizes the system, how well the outdoor unit is protected, and how often service should be scheduled are all decisions that follow from local exposure. The contractor you are matched with knows that picture for your area and works from it.
Georgia HVAC Contractor License Requirements for Installation and Repair
Georgia sets its own requirements for who may perform HVAC installation and repair work in the state. The provisions below are drawn directly from state sources, not paraphrased.
Georgia licenses conditioned air contractors in two classes and the size of the equipment decides which one is needed: a Class I licence is restricted to systems no larger than 175,000 BTU of heating and 60,000 BTU of cooling, and a Class II licence is unrestricted.
A state license for this trade determines who is legally permitted to do this work on your home. Contractors who cannot show they meet Georgia's requirements are not operating within the law, regardless of what they quote you. Every contractor this site routes a request to holds the license these provisions describe.
View the source provisions2 provisions
Georgia licenses conditioned air contractors in two classes and the size of the equipment decides which one is needed: a Class I licence is restricted to systems no larger than 175,000 BTU of heating and 60,000 BTU of cooling, and a Class II licence is unrestricted.
A Georgia conditioned air contractor licence is not granted on an application alone: the State Construction Industry Licensing Board requires documented field experience, a score of at least seventy on its examination, and its fees before it issues either class.